PLA wants a small amount of squish. If you run your finger over the surface it should feel smooth. If you feel the ridges you’re too low. And if it is wavy you’re super low.

Are you using node red or keeping all of this native?

I bought a cheap AIO PC on FB Marketplace and run HA’s front end on it. I also have the thermostat on an Amazon fire.

Each device has its own login so I can update what it sees. Eventually I want a 2F control, 1F control, and maybe use open hasp for thermostats. I’m also going to experiment using a raspberry pi or esp32 and gpio buttons.

If I were going to spend a little more cash I think I’d get a Chromebook that has a detachable screen and use that.

Looks like textbook too close to the bed. What firmware are you running, are you able to baby step while printing? Also what filament are you printing?

I looked at your post history and you’re overwhelming negative on a very small platform that tends to be people interacting with their best interests at heart. Maybe you grew up on 4chan, maybe you’re used to reddit griefing, either Lemmy doesn’t seem like a good place for you.

This is why I came here. I think you’d need at least three. One to work while the other sleeps, and a spare in case one gets injured.