Been daily driving low-profile Gateron switches for a while but wanted to give MX another shot. Mostly so I can use my nice keycaps again. I didn’t buy this filament specifically for this build but I think it works really nicely.

Switches are Ergo Clears, lubed and filmed with (IIRC) 45g springs. They were previously on an Ergodox and barely got any use as I switched to smaller boards shortly after modding them and wasn’t comfortable with desoldering yet, so I’m happy to have finally found a new home for them.

Caps are MT3 Godspeed, case is Overture Matte PLA (light blue and white), printed on the Sovol SV06 Plus.

  • v_krishna@lemmy.mlEnglish
    6·
    10 months ago

    It reminds me of a Stanley Mouse graphic used for a lot of Grateful Dead art

    • DeltaWhy@lemmy.worldOPEnglish
      2·
      10 months ago

      There are some similar boards with 3x6 layouts - ffkb and vulpes majora, both by fingerpunch, support 3x6 with a center trackball. I do miss the extra keys a bit with 3x5 layouts - when I eventually design my own board I think I’m going to do a 40 key layout.