What do you use as a case for the esp32? I can’t find premade ones for it
Mostly 3d printed stuff but there are dozens of cases on Aliexpress.
Mind sharing one? Aliexpress doesn’t return anything for me
Thx!
If you are in Central Europe I can print some for you! :) you just have to pay shipping.
I am actually! :D pm
Openscad, just because…
https://www.printables.com/model/73924-esp32-devkit-v4-case-openscad
Probably convenient to have access to an 3D printer
Thanks! I’ll check if I can get access to one
I ran into the same with the “D1 Mini”. The few cases available were expensive for what they were and not a great fit for my needs.
If you have access to a 3D printer, there are some pretty good models on thingiverse and printables. But YMMV depending on which board you’re using.
Another possiblity… I wanted to permanently put one in my car, so having some basic protection with the least amount of bulk was important. I ended up buying some shrink tube large enough to go around the entire board (IIRC it was 40mm, 2:1 shrink ratio), got everything wired up, slid the tubing over and shrunk it down. Could probably “double wrap” for more complete coverage. Again, this is board dependent and worked well for the D1 since it doesn’t have pre-soldered pins.
Cheers!
That’s a great idea 😁 I’ll get back to that if I can’t get a box
