I’m looking to start keeping hardware for prints that need additional parts to complete them. A Pi case that I printed needed screws that I don’t have on hand and needed to go searching for some.
It got me thinking to keep a container of stuff ready that would get used often, but I don’t really know what to keep on hand. What do you have readily available?
I have a pack of M2-M5 screws + nuts + washers thats come in handy. Also, heat press inserts (if you have a soldering iron) can really help clean up designs. Again, I just have a M2-M5 pack with various lengths, and I think it even came with the soldering iron tips for each insert size.
I’ve had trouble finding Metric fasteners in my local hardware store, so I just buy variety packs online. Also, most 3D prints Ive run into use Metric sizes, with the occasional 6-32 screw here and there.
Zip ties are nice if you mess around with your printer or work on electronics (cable management).
M2, m3 and m5 bolts of various lengths,
The inserts and a tap. For weak connections, instead of the insets, I just tap out the hole.
Other hardware I keep on hand are wiring and soldering, resistors and other vitamins, smooth rods (for making pins, etc).
Mostly I buy what I need as i need it but things like electronics components, they tend to be more less bulk buys.
I wasn’t sure about what type of screws to get. I haven’t printed off enough that need them to know quite yet, but not having any also has held me back from printing those things.
I was thinking about springs, but it seems like there’s just too much variety to really keep much on hand.