I didn’t realize that, though it seems to run fine on my potato (Ryzen 5: 1400, 16GB DDR4, Radeon 6770) with the occasional stutter, locked at 30fps 1080p for the most part. I haven’t tried faster frame rates yet as I’m trying to mirror the feel of the game between both this system and my Deck.

Thanks for verifying.

Looks like I may be going back to an all metal hotend. I had some decent luck with a Creality Spider, though I’ve found that it isn’t in production and the choice of nozzles limited to pretty much the 04 nozzle that comes with most printers. What’s the CR-10 all metal hotend that is popular and useful and with a good variety of nozzles?

While I know I’m not going to get SLA level detail (which I have given up on for now as I keep busting the LCD of my resin printer every set of prints) I am still hoping I can get to something recognizable, usually at 3x size for the figure, which I could do with the CR10 head and the Spider. Problem is, haven’t been able to even begin to dial in the calibrations, which is what I’m asking for assistance with. Where is a good place to start my tests at?

Looks good, though adhesives are notorious for failing once they get warm a few times, and will fail eventually. I would totally put a couple of screws holding them up. Beyond that, love the setup.