Edit It’s 17:08 now and it still shows 3 minutes
Edit 2 It’s 17:15 now and it has been on 0 minutes for 3 full minutes…
Then the lying whore sings a cheerful little tune after it fucked up my schedule.
I much prefer hang drying.
- Less wear on the clothes
- Basically no energy cost (technically not correct but it’s really whatever)
- Free humidifying during the dry winters
- Fairly satisfying thing to do while listening to a podcast
The primary downside is that it’s no fun to do it when it rains, neither indoors or outdoors, but as long as you time your laundry well enough, it’s all good.
It’s -11°F where I am today, my family still lives in Jamaica and I envy their ability to hang their clothes so much.
It should be possible to hang your clothes indoors still, I guess. Outdoors as well I’ve been told, when it’s a bit below freezing, but I’ll admit that I’ve never actually tried that.
At home I hang most of the clothes, but we where at a short trip and we had some wet towels and swimgear, so de decided to just do one full laundry with most of our wet and dirty clothes. The first duration before I even started the cycle was that it should be done at about 16:10 it was actually done more than an hour later.
Our dryer does this to us:
Put clothes in, start it - it estimates 35 units of time. Come back in 15 minutes to check, it says 15 units left. Come back in 15 minutes, it now says 21 units left.
I am, like all of us, unsure of the fundamental nature of time. But the dryer even more so. The units are not one standard length, and they don’t move always in the same direction.
Time to clean your dryer venting.
And camera lens.
and the microphone.
just in case they couldn’t spy correctly anymore.
I’ve never seen a heat pump dryer with an accurate countdown.
Had me in the first half… they’re up there with drawer style microwaves.
My dryer has a couple different presets which all adjust the remaining time dynamically according to a predetermind dryness level. To get around this, I just use the “custom” setting and change the temperature and timer manually.
The developers just put their own logic into its estimation software.
Kind of like estimations in software development.
Lies. They’re very reliable. You can rely on them to be wrong.
Take whatever timeline you have and double it. Then add 6 more weeks of cram.
estimations in software development are much less reliable IMO
I much prefer an estimating timer that reliably dries all the clothes rather than a reliable timer that estimates the clothes are dry.
Our washer does this too though
It might weigh it before washing, then keep doing the spin cycle until the weight gets close enough to the starting weight
Good shout. Most of the cycles do their best to get rid of excess moisture
Im still waiting for the last edit OP, dont leave us hanging
I think it was 17:18 when the door lock finally opened. The very first time estimate said it should be ready at 16:10. So it was definitely a big lie.
It’s not always the fault of the device. It estimate the time based on the download speed in this moment, but it can’t know that in the next moment your ISP server slows down or that your AV stops the download for some times to analyze a suspicios file, things like this to make your day enjoyable. Because of this, never automatic updates. I recieve an notification if there is an update in the queue and so I can update when I like in a spare time.
